EPS Control Unit Inputs and Outputs for Connector A (11P)
TERMINAL DESCRIPTION TABLE
| Terminal Number | Wire color | Terminal sign (Terminal name) | Description | Signal |
|---|---|---|---|---|
| 1 | PUR | IG-1 (Ignition 1) | Power source for Activating the system | With ignition switch ON (II): battery voltage |
| 3 | RED | CAN-L (CAN-LO) | CAN communication Circuit | With ignition switch ON(II): Pulses (1.5-2.5 V) |
| 5 | WHT | CAN-H (CAN-HI) | CAN communication Circuit | With ignition switch ON(II): Pulses (1.5-2.5 V) |
| 6 | PUR | MG2 (Motor ground) | Ground for the EPS Motor | -- |
| 7 | BLU | K-LINE (Data link connector) | Communicates with HDS | With service check signal opened: about 9-11 V |
| 8 | ORN | MG1 (Motor ground) | Ground for the EPS Motor | -- |
| 9 | LT BLU | NEP (Engine speed pulse) | Detects engine Speed signal | With engine running: pulses |
| 10 | BLK | PG (Power ground) | Ground for the EPS control unit | Continuity to ground |
| 11 | WHT | +B (Plus battery) | Power source for the Actuator EPS motor | Battery voltage at all times |