DTC B1058: Relay Control Module Lost Communication With Door Multiplex Control Unit (Door Lock Switch Message); DTC B1059: Relay Control Module Lost Communication With Door Multiplex Control Unit (Panic Message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
Are DTCs B1058 and/or B1059 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connections. ■
- Check for DTCs with the HDS.
B1058: Are DTCs B1006 and B1160 also indicated? B1059: Is DTC B1010 also indicated?
YES -Do the door multiplex control unit input test (see DOOR MULTIPLEX CONTROL UNIT INPUT TEST ). ■
NO -Do the relay control module input test (see RELAY CONTROL MODULE INPUT TEST ). ■