Interface Dial 5P Connector

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

TERMINAL VOLTAGE REFERENCE TABLE

Terminal Number

Wire Color

Terminal Name

Description

Voltage (about)

Symptom

WHT

JOG

Interface dial operation signal

0-5 V pulses

If open: You can not operate navigation system.
If short to ground: You can not operate navigation system.

BRN⁽¹⁾

JOG SH (Jog shield)

Shield for terminal No. 1

BLK

GND (Ground)

Ground for interface dial (G403)

0 V

If open: You can not operate navigation system.
If short to ground: You can not operate navigation system.

PUR

ACC (Accessory)

Power source for interface dial

Battery voltage at ACCESSORY (I)

If open: You can not operate navigation system.
If short to ground: Blows fuse No. 35 (10 A) in the under-dash fuse/relay box.

⁽¹⁾	The shielded wires have a heat-shrunk tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.

Fig 1: Identifying Interface Dial Inputs & Outputs For 5P Connector Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.