LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery & Battery Insulator
    GM662922Courtesy of GENERAL MOTORS CORP.
  1. Install the battery insulator, if necessary.
  2. Install the battery.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the battery hold down retainer and bolt.

    Tighten:  Tighten the battery hold down retainer bolt to 25 N.m (18 lb ft).

  4. Connect the positive battery cable.

    Tighten:  Tighten the positive battery cable bolt to 17 N.m (13 lb ft).

    5. Fig 2: View Of Negative Battery Cable At Battery
    GM832902Courtesy of GENERAL MOTORS CORP.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) .
scientia non olet · About LEMON Manuals