Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Battery Cables At Junction Block

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the generator cable (2) to the junction block.
Install the generator cable nut.
Tighten: Tighten the nut to 9 N.m (80 lb in).
Close the positive cable junction block.

Fig 2: View Of Generator Cable & Nut

Courtesy of GENERAL MOTORS CORP.

Install the generator cable to the generator, perform the following:
1. Install the generator cable to the stud.
2. Install the generator cable nut.
  Tighten: Tighten the nut to 9 N.m (80 lb in).
3. Position the boot to cover the stud.

Fig 3: View Of Negative Battery Cable At Battery

Courtesy of GENERAL MOTORS CORP.

Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) .