Installation Procedure
- Route the cable through the hole in the floor panel.
- Ensure that the steering column shift lever is in the park position.
- Install the cable grommet to the floor panel.
- Install the cable end (1) to the floor shift control assembly ball stud.
Courtesy of GENERAL MOTORS CORP.
- Install the console. Refer to Console Replacement
.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle
.
Courtesy of GENERAL MOTORS CORP.
- Ensure that the transmission manual shaft lever is in the mechanical park position.
- Install the range selector cable into the bracket at the transmission.
- Install the cable retaining clip.
- Install the range selector cable end (2) to the transmission range selector lever ball stud (1).
- Lower the vehicle.