Lubricant Level Inspection - Front Drive Axle

Lubricant Level Inspection - Front Drive Axle

1. Raise the vehicle. Refer to Vehicle Lifting.
2. Make sure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Remove the engine protection shield (if equipped).
5. Clean the area around the front axle fill plug (1).





6. Remove the front axle fill plug (1).
7. Inspect the oil level.
The oil level should be between 0 - 10 mm (0 - 0.375 inch) below the fill plug opening.
8. If the level is low, add oil until the level is even with the bottom edge of the fill plug opening. Use the proper fluid.

9. Install the fill plug.
^ Tighten the plug to 33 Nm (24 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

10. Install the engine protection shield.
11. Lower the vehicle.