LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Idler Arm Ball Stud Nut
    GM793270Courtesy of GENERAL MOTORS CORP.
  1. Install the relay rod to the vehicle.
  2. Install the relay rod to the pitman arm ball stud.
    3. Fig 2: View Of Idler Arm
    GM793272Courtesy of GENERAL MOTORS CORP.
  3. Install the relay rod to the idler arm ball stud. Verify that the seal is seated on the stud
    4. Fig 3: Seating The Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the J 29193  or the J 29194  . See Special Tools .
  5. Tighten the steering linkage installer in order to seat the tapers.

    Tighten:  Tighten the steering linkage installer to 54 N.m (40 lb ft).

  6. Remove the J 29193  or the J 29194  . See Special Tools .
  7. Install the new pitman arm prevailing torque nut.
  8. Install the new idler arm prevailing torque nut.

    Tighten:  Tighten the nuts to 60 N.m (44 lb ft).

  9. Install the outer tie rod assemblies. Refer to Tie Rod Replacement - Outer .
  10. Install the steering linkage shock absorber to the relay rod. Refer to Steering Damper Replacement .
  11. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  12. Lower the vehicle.
  13. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals