LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L - Introduction (2 Of 2) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: PCM & Engine Compartment
    GM863127Courtesy of GENERAL MOTORS CORP.
  1. Install the ECM to the ECM mounting bracket ensuring that the mounting tabs are engaged.
  2. Secure the spring latch to the ECM.
    3. Fig 2: PCM Harness Connectors
    GM863125Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Connect the ECM connectors to the ECM.

    Tighten:  Tighten the fasteners to 8 N.m (71 lb in).

    4. Fig 3: PCM Cover
    GM863123Courtesy of GENERAL MOTORS CORP.
  4. Install the ECM cover to the ECM mounting bracket, ensuring the mounting tabs on the ECM mounting bracket are engaged into the mounting holes in the ECM cover.
  5. If a new ECM is being installed, program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals