LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Keyless Entry System & Remote Functions) >> Diagnostic Information and Procedures >> Keyless Entry System Inoperative >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the transmitter is the correct transmitter for the vehicle.
    • If not the correct transmitter, replace the transmitter.
  2. Place the transmitter on the test pad of the J 43241  and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
    • If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter battery and retest with the J 43241  . If the condition continues after battery replacement, replace the transmitter.
  3. Verify the scan tool No. of Fobs Programmed parameter is greater than Fob 0.
  4. Operate the transmitter while observing the scan tool Door Lock Output and Door Unlock Output parameters. The parameter should correspond with the function selected on the transmitter.
    • If the parameter does not match the function selected on the transmitter, program the transmitter and retest. Refer to Transmitter Programming . If the condition continues after transmitter programming, replace the transmitter.
  5. With a scan tool, command the door locks to LOCK and UNLOCK.
    • If the door locks do not LOCK, test for a short to voltage or open/high resistance in the Driver Door Lock/ Window Switch LOCK signal circuit.
    • If the door locks do not UNLOCK, test for a short to voltage or open/high resistance in the Driver Door Lock/ Window Switch UNLOCK signal circuit.
  6. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals