Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying BPMV & EBCM

Courtesy of GENERAL MOTORS CORP.

Clean the sealing surfaces of the BPMV and the EBCM.
Install the EBCM (1) to the BPMV.

Fig 2: View Of EBCM Electrical Connector & Screws

Courtesy of GENERAL MOTORS CORP.

Install the EBCM screws (1).

NOTE: Refer to Fastener Notice .

Fig 3: View Of Tightening Sequence On EBCM

Courtesy of GENERAL MOTORS CORP.

Tighten the EBCM screws in the sequence shown (1-4).
Tighten: Tighten the screws to 5 N.m (44 lb in).
Connect the EBCM electrical connector.
Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (w/CE4) or Windshield Washer Solvent Container Replacement (w/o CE4) .
Install the front air deflector shield. Refer to Front Air Deflector Replacement .
Lower the vehicle.
If installing a new EBCM, program the EBCM. Refer to Control Module References .
Perform the Diagnostic System Check - Vehicle .