Circuit/System Verification

BCM and Wiper Switch Verification

1. Ignition ON, observe the scan tool Windshield Wiper Switch and the Wiper Delay Setting parameters. The Windshield Wiper Switch reading should display Off, Intermittent and Low and the Wiper Delay Setting should display 0-5 while rotating the wiper switch through each delay setting to the low position.
   • If one or more of the Wiper Delay Setting parameters are inoperative and the Windshield Wiper Switch low speed parameter functions, replace the turn signal/multifunction switch.
   • If the low speed parameter is inoperative, perform the Circuit/System Testing , under Multifunction Switch Circuit/System Testing and/or the Component Testing , under Multifunction Switch Component Test.
2. With the wiper switch in the HIGH speed mode, observe the scan tool Wiper High Speed Switch parameter. The Wiper High Speed Switch reading should be Active.
   • If not Active, perform the Circuit/System Testing , under Multifunction Switch Circuit/System Testing and/or the Component Testing , under Multifunction Switch Component Test.
3. Observe the scan tool BCM Wiper Park Switch parameter. The reading should display Active when the wipers are parked and Inactive with the wipers ON or out of the park position.
   • If the Wiper Park Switch parameter is always Active or Inactive, perform the Circuit/System Testing , under Wipers do not Park Circuit/System Testing.
4. If all wiper position parameters displayed correctly on the scan tool, perform the Circuit/System Testing , under Wiper Motor Circuit/System Testing and/or the Component Testing , under Wiper Motor Component Test.

BCM and Wiper Motor Verification

1. Command the windshield wiper motor to the off, low speed and high speed modes with a scan tool. Before commanding the wiper high speed mode, place the wiper switch in the low speed position. The wipers should perform the commanded state.
   • If one or more of the commanded states do not work, perform the Wiper Motor tests in Circuit/System Testing and/or Component test below.
2. If all the wiper motor speeds function, perform the Multifunction Switch Circuit/System Testing and/or the Multifunction Switch Component Test below.