Circuit/System Verification

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not install a module which has been previously installed in another vehicle or otherwise swap modules between vehicles. Swapping modules between vehicles will cause DTC B1016 to set.

Verify that DTC B1016 is not set.

IMPORTANT: When programming the VDAAW, use a Tech 2 and Candi module. Using the MDI to program the VDAAW will result in a failure to complete the programming operation.

If the DTC is set, perform the Vehicle Direction Alert Alarm Warning Module Programming and Setup procedure. If the DTC resets, replace the vehicle direction alert alarm warning module.