Vehicle Stability Control Module Programming and Setup
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Vehicle Stability Control Module (VSCM) Replacement and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
If the vehicle stability control module (VSCM) is replaced, the following procedures must be performed in the following order:
- VSCM Reprogramming--Refer to Service Programming System (SPS) .
- Revise the steering position sensor centering setup procedure using the Scan Tool module setup function.
- Revise the acceleration sensor reset procedure using the Scan Tool module setup function
- Revise the VSCM power steering reset procedure using the Scan Tool module setup function.