Body Control Module Programming and Setup: Introduction
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
The procedures below are designed to set-up the body control module (BCM) correctly during BCM related service. Before you start, read these procedures carefully and completely.
The following procedures must be followed:
- Programming the BCM
- Learning the restraints ID
- Programming Theft Deterrent System Components
- Program Key Fobs
- Program Tire Pressure Monitoring (TPM) System