Remote Control Door Lock Receiver
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
If the remote control door lock receiver (RCDLR) is replaced, the following procedures must be performed in the order listed below:
- Perform the Keyless Entry Transmitter Programming procedure. Refer to Transmitter Programming (North America, except Canada) or Transmitter Programming (Canada, Europe, Asia, Middle East) , using Method 2 to perform the programming.
- Perform the procedure to set up a new RCLDR:
- Connect the Tech 2 to the vehicle.
- Select RCDLR under Module Setup in the Vehicle Control System menu.
- Select Setup New RCDLR.
- Follow the on-screen instructions.
- Perform the 10-Minute Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming
.
When performing the relearn procedure, select Theft Deterrent Learn for ECM on the SPS terminal.
- Perform the Tire Pressure Sensor Learn procedure. Refer to Tire Pressure Sensor Learn .