Premium UZ6 System
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
6 Speaker System
- Two 6 inch high sensitivity speakers (HSS) mounted in both front doors.
- Two 6 x 9 extended range speakers (ERS) mounted to the rear shelf.
- Two tweeter speakers mounted in the upper door trim on both front doors.
Radio Features
| Controls | Base | Uplevel | ||
|---|---|---|---|---|
| Power | Push the Power ON/OFF knob to turn the radio ON. | |||
| Volume | The volume is adjusted by rotating the POWER knob. | |||
| DISP (Display) | Press DISP knob to switch the display between time, temperature, or radio frequency | Press DISP knob to switch the display between time, temperature, or radio frequency. For RDS, press DISP knob to change what appears on the display while using RDS. For XM™, if equipped, press DISP knob while in XM mode to retrieve four different categories of information related to the current song or channel. |
||
| SCV | N/A | Press the AUTO VOL button. Adjust the SCV by pressing the AUTO VOL until the desired volume setting appears on the display. Three settings are available; LOW, MEDIUM, and HIGH. |
||
| Tune | Turn the DISP/ADJ knob. | |||
| Seek | Press the SEEK-SCAN UP button within 2 seconds for radio to find next strong signal, in current band, of increased frequency. Press the SEEK-SCAN DOWN button within 2 seconds for radio to find next strong signal, in current band, of decreased frequency. |
|||
| Scan | Press and hold the SEEK-SCAN UP button longer than 2 seconds but less than 4 seconds. One audible beep is heard before it starts scanning. | |||
| Presets | Six AM, Six FM1 and Six FM2 | |||
| Preset Saving | Press and hold any User Preset button (1-6) greater than 2 seconds. One audible beep is heard. | |||
| Preset Scan | Press and hold SEEK-SCAN UP or SEEK-SCAN DOWN button at least 4 seconds. Two audible beeps are heard before it starts preset scanning. | |||
| Mute | Steering Wheel Audio Controls only. Press the MUTE button to silence the system. Press it again, or any other radio button, to restore the sound. |
|||
| Fade or Balance | Push and release the BAL/FADE knob, within 2 seconds, to select and adjust w/Adj knob. Pushing and holding the BAL/FADE knob longer than 2 seconds, before a particular setting is displayed, produces one audible beep and sets the fade/balance settings to the center detent. The radio displays ALL CENTERED. |
|||
| Bass, Treble or Midrange | Push and release the TONE knob, within 2 seconds, to select and adjust w/ADJ knob. Pushing and holding the TONE knob longer than 2 seconds, before a particular setting is displayed, produces one audible beep and sets the audio settings to the center detent. The radio displays ALL CENTERED. |
|||
| Automatic Tone Control (ATC) | N/A | Press and release the AUTO EQ button to choose and program preset bass and treble equalization settings. | ||