LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 5.3L - DTC P0016 To DTC P0333) >> DTC P0128 >> Circuit/System Verification
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, inspect the cooling system surge tank for the proper coolant level. Refer to Cooling System Leak Testing and Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac-N-Fill) .
  2. Ignition OFF for 8 hours or greater.
  3. Ignition ON, observe the scan tool IAT Sensor and ECT Sensor parameters. The ECT, IAT, and ambient temperatures should be within 6°C (11°F) of each other.
  4. Use the scan tool to verify the proper operation of the engine cooling system fans.
    5. IMPORTANT: A critical analysis of the operation of the thermostat is necessary to properly diagnose these DTC.
  5. Verify the proper heat range and the operation of the thermostat. Refer to Thermostat Diagnosis .
  6. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals