Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

If replacing the VCIM, record the 10-digit STID number, and the 11-digit ESN number from the labels on the new module.

Fig 1: View Of Bracket Tab

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the VCIM to the bracket ensuring the retaining tab (1) is fully seated.
Tighten: Tighten the screw fully driven, seated and not stripped.

Fig 2: View Of VCIM Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the VCIM electrical connectors as necessary.

Fig 3: View Of Right I/P Service Panel

Courtesy of GENERAL MOTORS CORP.

Install the service panel.

IMPORTANT: After replacing the VCIM, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.

Reconfigure the OnStar® system. Refer to Control Module References .