Installation procedure
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- When replacing the VCIM, record the 11-digit electronic serial number (ESN) and the 10-digit station identification (STID) number from the label on the new VCIM.
- Reconnect the electrical connectors the module.
- Install the module onto the vehicle.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
- Install the scan tool. Use the special functions menu in order to perform the OnStar® setup procedure for this vehicle.
- Move the vehicle to an open area that is away from tall buildings and with a clear view of unobstructed sky. Allow the vehicle to run for 10 minutes.
- Use the ID information menu on the scan tool to access the new station ID (STID) and the electronic serial number (ESN) from the new VCIM.
- Press the blue OnStar® button to connect to the OnStar® Call Center and perform the following procedure:
- Tell the advisor that this vehicle has received a new VCIM.
- Ask the advisor to add the new STID and the ESN to update the customer's account.
- Follow any additional instructions from the OnStar® advisor.
- Ask the advisor to activate the OnStar® Personal Calling feature, if available.
- The default language for the new VCIM is English. Refer to the Module Setup screen if the customer requests French or Spanish Voice Recognition.
- Refer to Control Module References for programming and set up information.
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
After replacing the vehicle communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.