LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Wiring Components
    GM1313641Courtesy of GENERAL MOTORS CORP.
  1. Insert the generator positive cable (3) into the battery cables harness conduit.
    2. NOTE: Refer to Fastener Notice .
  2. Connect the generator lead (5) to the generator and install the generator output BAT terminal nut (6).

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  3. Press the protective boot (4) on to the generator output BAT terminal (2).
    4. Fig 2: Locating Positive Cable
    GM1313640Courtesy of GENERAL MOTORS CORP.
  4. Install the nut (2) securing the generator positive cable (5) to the underhood fuse block (1).

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  5. Install the underhood fuse block cover to the underhood fuse block, engaging the locking tabs.
    6. Fig 3: View Of Battery Cable Harness Retainer
    GM1313637Courtesy of GENERAL MOTORS CORP.
  6. Close the battery cables harness retainer (3).
  7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals