Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: I/P Module & Fasteners

Courtesy of GENERAL MOTORS CORP.

Route the I/P module pigtail down through the I/P.
Install the I/P module to the instrument panel.

CAUTION: Refer to Fastener Caution .

Install the I/P module mounting fasteners and tighten to 9 N.m (80 lb in).

Fig 2: I/P Module Wire Harness

Courtesy of GENERAL MOTORS CORP.

Route the I/P module wiring harness in place to secure the I/P module yellow 2-way connector clip.
Install the I/P retainer. Refer to Instrument Panel Retainer Replacement .
Install the I/P module yellow connector to the vehicle harness yellow connector.
Install the CPA to the instrument panel module connector.
Enable the SIR system. Refer to SIR Disabling and Enabling .
After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflatable Restraint Module Handling and Scrapping for proper disposal.