Testing Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Wipe clean the differential case, the ring gear and the differential carrier housing of lubricant. Carefully clean each tooth of the ring gear.

Fig 1: View Of Ring Gear Teeth Pattern

Courtesy of GENERAL MOTORS CORP.

Use a medium stiff brush in order to sparingly apply gear marking compound GM P/N 1052351 (Canadian P/N 10953497) or equivalent to all of the ring gear teeth.

IMPORTANT: Avoid turning the ring gear excessively.

Using a wrench, turn the drive pinion flange/yoke so that the ring gear rotates at least 3 full revolutions.
Turn the drive pinion flange/yoke in the opposite direction so that the ring gear rotates at least 3 full revolutions in the opposite direction.
Observe the pattern on the ring gear teeth. Compare the pattern with the following illustrations.
Once the proper pattern is obtained, continue the assembly of differential carrier. Refer to Differential Carrier Assembly - Assemble .