LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Lighting System) >> Diagnostic Information and Procedures >> DTC B0530 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the IPC.
  2. Verify a test lamp illuminates between the ground circuit terminal 4 and B+.
    • If the test lamp does not illuminate, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the control circuit terminal 6 and the ground circuit terminal 4.
  4. Ignition ON, command the left turn signal ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the IPC.
scientia non olet · About LEMON Manuals