SFI Control Relay Test
CAUTION:
When applying direct battery voltage, ensure voltage is applied to correct terminal to prevent relay damage.
- Remove control relay. Relay is located behind lower left side of dashboard.
- Apply battery voltage across terminals No. 6 (positive) and No. 8 (negative) while checking voltage on terminals No. 1 and 2. Battery voltage should exist. Apply battery voltage across terminals No. 7 (positive) and No. 10 (negative) while checking continuity between terminals No. 3 and 4. Continuity should exist.
- Apply battery voltage across terminals No. 3 (positive) and No. 9 (negative) while checking voltage at terminal No. 4. Battery voltage should exist. Replace relay if it fails any test.