Anti-Lock Braking System Control Module: Installation
- Install the HECU, then connect the brake lines.
Tighten the HECU mounting bolts and brake tube nuts to the specified torque.
Tightening torque
HECU mounting bolt:
8 ~ 10 Nm (80 ~ 100 kg.cm, 6 ~ 7.3 lb.ft)
Brake tube nut:
13 ~ 17 Nm (130 ~ 170 kg.cm, 10~12 lb.ft)
- Connect the HECU connector.
- Bleed the brake system.
- Start the engine, and check that the ABS indicator goes off.
- Test-drive the vehicle, and check that the ABS indicator does not come on.