LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2006 >> Santa Fe GLS, 2.7 D, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA-GSL 2.7) >> Gasoline Engine Control System >> Throttle Body >> Cleaning
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Body: Cleaning

NOTE: Disconnect the intake air hose from the throttle body, and check the throttle valve surface for carbon deposits. Spray cleaning solvent on the valve to remove carbon deposits.
  1. Warm up the engine, then stop it.
  2. Remove the intake air hose from the throttle body.
  3. Plug the bypass passage inlet of the throttle body.
    NOTE: Make sure the solvent does not enter the by-pass passage.
    Fig 1: Identifying Bypass Passage Inlet Of Throttle Body
    G04932153Courtesy of HYUNDAI MOTOR CO.
  4. Spray cleaning solvent onto the valve through the throttle body intake port and let it soak for about 5 minutes.
  5. Start the engine, race it several times and allow the engine to run near idle for 1 minute.
  6. Repeat Steps  4 and  5.
  7. Unplug the bypass passage inlet.
  8. Attach the intake air hose.
  9. Disconnect the battery ground cable for more than 10 seconds.
    Fig 2: Checking Throttle Valve Surface For Carbon Deposits
    G04932154Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals