Signal Circuit Inspection

Check for open in signal circuit
1. Ignition "ON" & Engine "OFF"
2. Measure voltage between terminal 3 of the FTPS harness connector and chassis ground
  Specification : Approx. 5V
3. Is voltage within the specification?
  YES
  - Go to next step as below
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
Check for short to battery in signal circuit
1. Ignition "OFF"
2. Disconnect ECM connector
3. Ignition "ON" & Engine "OFF"
4. Measure voltage between terminal 3 of the FTPS harness connector and chassis ground
  Specification : Approx. 0V
5. Is voltage within the specification?
  YES
  - Go to next step as below
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure