Component Inspection
- Ignition "OFF"
- Disconnect OTS connector.
- Measure resistance between terminals 1 and 2 of OTS connector. (Component side)
SPECIFICATION
OTS RESISTANCE REFERENCETemp. (°C) Temp. (°F) OTS Resistance (kΩ) 20 68 2.45 40 104 1.11 80 176 0.29 - Is sensor switching properly?
YES:
- Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO:
- Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.