Alarm Module: Service and Repair

IMMOBILIZER CONTROL UNIT

REMOVAL
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad.
3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) and bracket (B) after loosening a shear bolt (C).

NOTE:
- Punch the shear bolt using a centering punch.
- And drill its head off with a drill bit.
- Be careful not to damage the SMARTRA unit.






INSTALLATION
1. Install the immobilizer control unit and bracket after connecting the unit connector.

NOTE: Tighten the shear bolt until the bolt head break off.

2. Install the crash pad.