LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2009 >> Elantra GLS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures >> DTC P0605 Internal Control Module Read Only Memory (ROM) Error >> Monitor DTC Status
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor DTC Status

  1. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode.
  2. Press F4 (DTAL) to select DTC information from the DTCs menu.
  3. Confirm that "DTC Readiness Flag" indicates "Complete". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
  4. Read "DTC Status" parameter.
  5. Is parameter displayed "History (Not Present) fault"?
    NOTE:
    • History (Not Present) fault: DTC occurred but has been cleared.
    • Present fault: DTC is occurring at present time.

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals