LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2009 >> Elantra SE, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures >> DTC P0501 Vehicle Speed Sensor A Range/Performance >> Monitor SCANTOOL Data
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Monitor SCANTOOL Data

  1. With vehicle raised on a lift, start the engine and place transaxle in Drive. Let vehicle idle and verify speedometer indicates approx. 10km/h or more (6mph or more) on the instrument cluster.
  2. Connect Scantool and select ABS system.
  3. Monitor the "WHEEL SPD SENSOR-FR" parameter on the current data list.

    Specification:  10km/h or more (6mph or more)

  4. Is value within the specification?

    YES 

    NO 

    • Check for open or short circuit between wheel speed sensor (FR) and ABS control module

      If problems are found, repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

      If OK, Check wheel speed sensor (FR) as follow:

      • Gap between ABS sensor and trigger wheel (Air gap: 0.3~1.1 mm (0.011 ~ 0.043 in))
      • Trigger wheel condition
      • Sensor resistance: Approx. 1,300~1,500Ω at 20°C (68°F)

      Replace wheel speed sensor as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals