October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
DTC P2270 O2 Sensor Signal Stuck Lean (Bank 1/Sensor 2): DTC Detecting Condition
DTC P2270 DETECTING CONDITION TABLE
| Item |
Detecting Condition |
Detecting Condition |
| DTC Strategy |
- Plausibility check during shift of lambda setpoint to rich or lean
|
- Poor connection or damaged harness
- Rear HO2S
|
| Enable Conditions |
- No fuel cut-off
- No full load phase
- No fuel trim error detected
- Delay time to start diagnosis: 13 ~ 30 sec, depending on operation point
- 11V < Battery voltage < 16V
- No relevant failure
|
| Threshold Value |
- Rear HO2S signal < 0.75V when lambda set point = 0.80
|
| Diagnostic Time |
|
| MIL On Condition |
|