Component Inspection

1. Ignition "ON" & Engine "OFF".
2. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode.
3. Using a scantool, Clear DTC.
4. Using a "SCAN TOOL", Operate "LEARNING" Reset,
5. Perform the "LEARNING"
6. IG OFF ↔ IG ON (Repeat 2~3times), and then Monitor the "DTC"
7. Is DTC Redisplayed?

   YES 

   • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO 

   • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. And Go to COMPONENT INSPECTION  procedure.

METHOD OF LEARNING RESET

* IT IS NECESSARY TO LEARNING RESET, AFTER REPLACED TRANSMISSION

1. ERASING CONDITION
   1. SELECT LEVER POSITION IS "P" OR "N"
   2. VEHICLE SPEED = 0 km/h
   3. IGNITION "ON", ENGINE "OFF"
2. USING A SCAN TOOL, OPERATE "LEARNING" RESET
3. IG "ON" ↔ IG "OFF" (2~3 TIMES), AFTER RESET