Component Inspection

Check SMARTRA
1. IG "ON" & Engine "OFF"
2. Neutralize Both "SMARTRA" and "ECM" and Register transponder key by scantool.
  NOTE: Pin code is required to Neutralize SMARTRA and to Register transponder key
3. Are Neutralizing and Registering completed normally?
  YES
  - Perform all the key teaching procedure with scantool. (All the keys must be retaught) and then, go to "VERIFICATION OF VEHICLE REPAIR " Procedure.
  NO
  - Substitute with a known-good SMARTRA and Perform Key teaching procedure.
  - If the problem is corrected, replace SMARTRA and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.