LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2010 >> Santa Fe GLS, 2.4 B, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.4L >> Camshaft Position Sensor (CMPS) >> Repair procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Removal

WARNING:
  • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1/Intake] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
    Fig 1: Identifying Camshaft Position Sensor Connector With Installation Bolt (Intake)
    G06846845Courtesy of HYUNDAI MOTOR CO.

[Bank 1/Exhaust] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the hanger and the protector.
  4. Remove the installation bolt (B), and then remove the sensor.
    Fig 2: Identifying Camshaft Position Sensor Connector With Installation Bolt (Exhaust)
    G06846846Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals