Inhibitor Switch: Installation

Temporarily install the neutral start switch with the new seal bolt.
Bolt size (10): M8x1.25x30mm (Seal bolt)

CAUTION: Tighten the bolt after adjusting the neutral start switch to "N" position.

Fig 1: Identifying Seal Bolt
Courtesy of HYUNDAI MOTOR CO.
Install the washer and the lock washer with the nut.
Tightening torque :

6~8 Nm (0.6~0.8 kgf.m, 4.34~5.78 lb-ft)

Fig 2: Identifying Lock Washer And Washer
Courtesy of HYUNDAI MOTOR CO.
Using a screwdriver, stake the lock washer.

Fig 3: Staking Lock Washer
Courtesy of HYUNDAI MOTOR CO.
Adjust the manual valve lever shaft to "N" position.
Set SST to the manual valve lever shaft.
Align the reference line of the special service tool (09452-3M400) with the neutral reference line of the neutral start switch, and tighten the bolt.
Tightening torque :

10~16 Nm (1.0~1.6 kgf.m, 7.23~11.57 lb-ft)

Fig 4: Identifying Special Service Tool (09452-3M400)
Courtesy of HYUNDAI MOTOR CO.
Adjust the manual valve lever shaft to "P" position.
Install the shift control cable assembly and the connector to the neutral start switch.