Visual Identification
Please pay attention to the following when installing or removing transaxle.
- Handling with care for electronic parts
- When replacing an electronic part, be sure to switch the ignition off and disconnect the battery from the negative (-) terminal before servicing the system.
- Do not jar electronic parts. If a part is dropped or shocked, replace it with a new one.
- Prevention of foreign substances
- Be sure to remove dust, sand, etc. thoroughly from A/T when removing an associated part from it.
- Protect the removed part from dust by covering it with a plastic bag, etc.
- Perform the service procedures using plastic gloves, and do not use work gloves or a rag.
- Prevention of part damage
- When separating an attached surface of the case, etc., tap with a plastic hammer to take the parts apart. [DO NOT PRY PARTS OFF WITH A SCREWDRIVER, ETC.]
- Do not pull out the valve, etc. with excessive force.
- Cleaning of parts
- All parts have to be thoroughly cleaned, dried by blown air and coated with the specified oil.
- Do not clean aluminum parts and rubber parts with alkaline chemicals.
- Do not clean rubber parts with washing oil (white gasoline).
- Caution for handling ATF
- Do not drain ATF while it is still hot. (Service the system after it cools down).
- Be sure to use JWS-3309 (T-IV) type ATF.