Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode
2. Using a GDS, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed at or above 10kmh. (6.2mph))
4. Using a GDS, Check DTC present.
5. Are any DTCs present?

   YES 

   Go to the applicable troubleshooting procedure.

   NO 

   System performing to specification at this time.