LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2013 >> Genesis Coupe 2.0T, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System - 3.8L) >> Engine Control Module (ECM) >> Repair Procedures >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Repair Procedures: Removal

WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure together (Refer to TEACHING PROCEDURES ).
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the cover.
  3. Disconnect the ECM connector (A).
    4. Fig 1: Identifying ECM Connector, Bracket Bolts, & Nut
    G06511457Courtesy of HYUNDAI MOTOR CO.
  4. Remove the ECM bracket installation bolts (B) and nut (C).
  5. After removing the installation bolts, remove the ECM from the bracket.
scientia non olet · About LEMON Manuals