Repair procedures: Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
- Perform NEUTRALIZING OF ECM
.
Refer to IMMOBILIZER SYSTEM .
- After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS.
Refer to IMMOBILIZER SYSTEM .
[In the case of installing new ECM]
Perform TEACHING PROCEDURES .
Refer to IMMOBILIZER SYSTEM .
CAUTION:
When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
- Perform NEUTRALIZING OF ECM
.
Refer to SMART KEY SYSTEM .
- After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Disconnect the ECM Connector (A).
- Remove the battery.
Refer to BATTERY .
- Remove the air cleaner assembly.
Refer to AIR CLEANER .
- Remove the mounting bolts (A) and nut (B), and then remove the ECM assembly (C).
- Remove the installation nuts (A) and screws (B), remove the ECM (C) from the bracket.