Repair Procedures: Removal

Disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to: Engine Mechanical System - "INTAKE & EXHAUST SYSTEM ").
Remove the under cover (A).
Tightening Torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 1: Locating Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to: Hydraulic System - "FLUID ").
Remove the air breather hose (A).
Remove the valve body cover (B).
Tightening :

13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)

NOTE: Remove installation bolts in the engine compartment first and then remove others under the vehicle.

Fig 2: Air Breather Hose And Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the plate and the detent spring (B) after removing the bolt (A).
Tightening :

11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

Fig 3: Plate And Detent Spring Location
Courtesy of HYUNDAI MOTOR AMERICA
Remove the bolt (3EA) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening Torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CAUTION: Be careful not to damage the harness lock connector.

Fig 4: Oil Temperature Sensor And Solenoid Valve Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Remove the valve body assembly (A).
Tightening Torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 5: Valve Body Assembly Location
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the input & output speed sensor connector (A).
Remove the input & output speed sensor (B) after removing the bolts (2EA).
Tightening Torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 6: Input & Output Speed Sensor Bolts
Courtesy of HYUNDAI MOTOR AMERICA