Repair Procedures: Removal

[Bank 1/Sensor 1] 

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the connector (A), and then remove the sensor (B).

   Information 

   Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.

   Fig 1: Identifying Heated Oxygen Sensor Connector (Bank 1/Sensor 1)

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 2: Identifying Heated Oxygen Sensor (Bank 1/Sensor 1)

   Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Sensor 2] 

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the console side cover (A).
   Fig 3: Identifying Console Side Cover (Bank 1/Sensor 2)

   Courtesy of HYUNDAI MOTOR AMERICA
3. Disconnect the connector (A), and then remove the sensor (B).

   Information 

   Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.

   Fig 4: Identifying Heated Oxygen Sensor Connector

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 5: Identifying Heated Oxygen Sensor

   Courtesy of HYUNDAI MOTOR AMERICA