Repair Procedures: Installation

CAUTION:

When installing, set room side Shift lever and T/M side lever to 'N' position.

Install the control cable (B) and clip (A) on the bracket.

Fig 1: Removing Control Cable And Clip On Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Install the washer (B) and pin (A).

Fig 2: Removing Washer And Pin
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the nut (B) after install the retainer (A).
Tightening Torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Fig 3: Installing Retainer
Courtesy of HYUNDAI MOTOR AMERICA
Install the crash pad and cowl cross bar.
(Refer to: Body - "COWL CROSS BAR ASSEMBLY ").
Install the heater unit.
(Refer to: Heating, Ventilation, Air Conditioning - "HEATER UNIT ").
Install the cable guide (B) on lever assembly.

Fig 4: Installing Cable Guide On Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) and clip (A).

Fig 5: Installing Shift Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Shift lever to "3rd".
Install the snap pin (A) after install the select cable (B).
CAUTION:
- Install the snap pin (A) after adjust the select cable (B).
  (Refer to: "ADJUSTMENT Control Cable").
Fig 6: Installing Snap Pin And Select Cable
Courtesy of HYUNDAI MOTOR AMERICA
Install the air duct (A).

Fig 7: Installing Air Duct
Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to: Body - "FLOOR CONSOLE ").
Install the following parts.
1. Engine cover.
  (Refer to: Engine Mechanical System - "ENGINE COVER ").
2. Air cleaner assembly and air duct.
  (Refer to: Engine Mechanical System - "AIR CLEANER ").
3. Battery and battery tray.
  (Refer to: Engine Electrical System - "BATTERY ").