Repair Procedures: Removal

Remove the floor console assembly.
(Refer to: Body - "FLOOR CONSOLE ").
Remove the air duct (A).

Fig 1: Removing Air Duct
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.

Fig 2: Removing Select Cable Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) after removing the clip (A).

Fig 3: Removing Shift Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the cable guide (A) from lever assembly after pulling in the direction of the marker.

Fig 4: Removing Cable Guide From Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the crash pad and cowl cross bar.
(Refer to: Body - "COWL CROSS BAR ASSEMBLY ").
Remove the heater unit.
(Refer to: Heating, Ventilation, Air Conditioning - "HEATER UNIT ").
Remove the retainer (A) after loosen the nut (B).

Fig 5: Removing Retainer Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the following parts.
1. Engine cover.
  (Refer to: Engine Mechanical System - "ENGINE COVER ").
2. Air cleaner assembly and air duct.
  (Refer to: Engine Mechanical System - "AIR CLEANER ").
3. Battery and battery tray.
  (Refer to: Engine Electrical System - "BATTERY ").
Remove the shift & select cable.
1. Remove the pin (A) and washer (B).
2. Make unlock clip (C) and then remove the shift & select cable and the clip (C) from the bracket.
  
  Fig 6: Removing Pin, Washer And Shift & Select Cable Clips
  Courtesy of HYUNDAI MOTOR AMERICA
  NOTE:
  - DO NOT reuse the clip (C).
Remove the shift cable at cabin room.