Repair Procedures: Removal

Remove the following parts;
1. Engine cover.
  (Refer to: Engine Mechanical System - "ENGINE COVER ").
2. Air cleaner assembly and air duct.
  (Refer to: Engine Mechanical System - "AIR CLEANER ").
3. Battery and battery tray.
  (Refer to: Engine Electrical System - "BATTERY ").
Set shift lever to 'N' position.
Separate the control cable from the control shaft after remove the pin (A) and washer (B).

Fig 1: Removing Pin And Washer
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control shaft assembly after loosen the bolts.
Tightening Torque:

19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)

Fig 2: Removing Control Shaft Assembly
Courtesy of HYUNDAI MOTOR AMERICA