Transmitter Code Registration (Using Code Saver)

Open Door.
Connect POWER (B+) and GND, signal line of Code Saver.
If connection is normal, signal line is activated and RED LED turns ON.
If switch of Code Saver turns ON, data via signal line will be transmitted.
BCM enters into Code Save mode when it receives data from Code Saver and send Code Save Start signal via signal line.
Code Saver turns Green LED ON when it receives Code Save Start signal.
When you press Lock or Unlock button of transmitter, BCM will save Codes.
If there are 2 transmitters for Code Saving, register by performing item 7).

If switch of Code Saver turns OFF or is disconnected, Code Saving mode will be finished.

CODE SAVING METHOD DESCRIPTION

NO	Saved code	Code to change	Changed code
1	A	C	C (A is deleted)
2	A, B, C, D E	E	(A, B, C, D are deleted)
3	A, B	C, D, E	C, D
4	A, B	C, C, D	C