Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the accelerator position sensor connector (A).

Fig 1: Identifying Accelerator Position Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.

Fig 2: Identifying Accelerator Pedal Module Installation Bolt
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Identifying Accelerator Pedal Module Nut
Courtesy of HYUNDAI MOTOR AMERICA