Wheel Alignment: Toe: [Front]
Toe-in (B-A or angle a+b) is adjusted by turning the tie rod turnbuckles. Toe-in on the left front wheel can be reduced by turning the tie rod toward the rear of the car. Toe-in change is adjusted by turning the tie rods for the right and left heels simultaneously at the same amount as follows.
Standard value:
Toe-in
Manual (Total/Individual): 0°±0.2°/0°±0.1°
AIR (Total/Individual): 0°±0.2°/0°±0.1°
NOTE:
- Toe-in adjustment should be made by turning the right and left tie rods at the same amount.
- When adjusting toe-in, loosen the outer bellows clip to prevent twisting the bellows.
- After the adjustment, tighten the tie rod end lock nuts firmly and reinstall the bellows clip.
- Adjust each toe-in to be the range of ±1°.
Tie rod Specified torque:
50~55N.m (5.0~5.5kgf.m, 36.2~39.8lb-ft)