Repair Procedures: Removal

Bank 1 

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the intake hose.

   (Refer to "AIR CLEANER ")

3. Disconnect the camshaft position sensor connector (A).
4. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

   Bank 1/Intake 

   Fig 1: Camshaft Position Sensor And Connector (Bank 1/Intake)

   Courtesy of HYUNDAI MOTOR AMERICA

   Bank 1/Exhaust 

   Fig 2: Camshaft Position Sensor And Connector (Bank 1/Exhaust)

   Courtesy of HYUNDAI MOTOR AMERICA

   Bank 2 

   WARNING:

   • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. In this case, the hot engine oil could lead or cause burns.
   1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
   2. Remove the surge tank.

      (Refer to "SURGE TANK ")

   3. Disconnect the camshaft position sensor connector (A).
   4. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

      Bank 2/Intake 

      Fig 3: Camshaft Position Sensor Connector And Mounting Bolt (Bank 2/Intake)

      Courtesy of HYUNDAI MOTOR AMERICA

      Bank 2/Exhaust 

      Fig 4: Camshaft Position Sensor Connector And Mounting Bolt (Bank 2/Exhaust)

      Courtesy of HYUNDAI MOTOR AMERICA